1
General Mach Discussion / X axis working only in one direction
« on: May 08, 2019, 08:45:35 AM »
Hello,
Since I redid the installation of Mach3 on my laptop (with the appropriate files for my G540 and UC 100) , I can not jog my axes as before.
For example, my X axis always works in the same direction, no matter if I use the left or the right arrow.
I tried a reset of my Hotkeys without success
However, with my PC everything works fine.
Do you have an idea of the problem with my laptop?
Thanks
Jack
Since I redid the installation of Mach3 on my laptop (with the appropriate files for my G540 and UC 100) , I can not jog my axes as before.
For example, my X axis always works in the same direction, no matter if I use the left or the right arrow.
I tried a reset of my Hotkeys without success
However, with my PC everything works fine.
Do you have an idea of the problem with my laptop?
Thanks
Jack