Topics

1

General Mach Discussion / Lazycam "Pro Demo.No GCode" but have Mach3 license?

« on: May 06, 2019, 05:18:14 PM »

Just trying to test some stuff and lazycam is saying Pro Demo.No GCode but have a mach3 license from a few years ago and mach3 works.. pasted file in folder etc so figured that was included. Anyone have this odd issue?

2

General Mach Discussion / Nema34 to Mach3 IB connected to DQ860MA

« on: May 02, 2019, 03:28:11 PM »

Just trying to connect these two steppers to mach3 . Have to have something wrong.  Do you guys have settings for the 85bygh450d-008 stepper connected to DQ860MA to a generic "mach3 interface board"
I cant get them to move at all really. Few connections are as below:
red A+
green A-
YellowB+
BlueB-
Pins are set to X 2, 3
Z 6, 7
^steplow

25000hz

estop 1, 10 active low

motor tune
1600 400 200 0 0 on both