1
General Mach Discussion / Mach3 X/Y/Z Step Pin & Dir Pin #
« on: May 02, 2019, 12:35:10 PM »
I have a older CNC Router (Windows 98) that I would like to upgrade to Mach3, I downloaded the Demo version and when I went to configure it, it is asking me for Step Pin #, and Dir Pin # (along with Step Port, and Dir Port), I don't have any information that shows what numbers I should enter here, is there a way to determine what my current setup is? I'm not sure how to proceed with this.
Thank You
Pat W.
PDJ Cutting and Fabricating
Thank You
Pat W.
PDJ Cutting and Fabricating