1
Mach4 General Discussion / Button config for manual toolchange
« on: May 01, 2019, 04:58:00 PM »
Hello together,
my name is Oliver and I'm from Germany, my english is not so good please excuse
I'm new in Mach4 and my skills in Mach4 are at the beginning.
I want to change a tool by pressing an external Button (it's an ATC-Spindel, air pressed for tool change).
I think the Input Signal from this button must be mapped to the Output signal for the magnetic valve for the spindle, but how can I do that.
In the future the tool change should be automatically, but step by step.
My Controller is a csmio/ip-s, the machine is a DIY-milling machine
Please, can anybody help me?
Greetings
Oliver
my name is Oliver and I'm from Germany, my english is not so good please excuse
I'm new in Mach4 and my skills in Mach4 are at the beginning.
I want to change a tool by pressing an external Button (it's an ATC-Spindel, air pressed for tool change).
I think the Input Signal from this button must be mapped to the Output signal for the magnetic valve for the spindle, but how can I do that.
In the future the tool change should be automatically, but step by step.
My Controller is a csmio/ip-s, the machine is a DIY-milling machine
Please, can anybody help me?
Greetings
Oliver