Guest
Show Posts
1
Mach4 General Discussion / Tangential knife Mach 4
« on: April 25, 2019, 05:25:12 PM »
I have a problem with Mach 4 and tangential knife.
I have bought EOT 3 head with this tangential oscilating knife. I use it to cutt rubber with it. It works great, until I do not go and cutt holes (various dimensions ) with it.
What is happening, is that knife is not finishing holes to the end....it does not make 360 degrees turn, but instead it goes up to cca 355 degrees. It also remember that as new 0 degree position of knife and makes another 355 degrees turn, this makes holes larger and larger and also not finnished to the end...and this is continuing until i do not stop it and correct knife manualy.
On picture you can see corrected and not corrected hole.
I would be glad for any kind of help.
Thank you.
I have bought EOT 3 head with this tangential oscilating knife. I use it to cutt rubber with it. It works great, until I do not go and cutt holes (various dimensions ) with it.
What is happening, is that knife is not finishing holes to the end....it does not make 360 degrees turn, but instead it goes up to cca 355 degrees. It also remember that as new 0 degree position of knife and makes another 355 degrees turn, this makes holes larger and larger and also not finnished to the end...and this is continuing until i do not stop it and correct knife manualy.
On picture you can see corrected and not corrected hole.
I would be glad for any kind of help.
Thank you.