1
General Mach Discussion / Help wiring limit switch to servo tec board
« on: April 21, 2019, 11:06:07 PM »
Noob here. I know very little about wiring, luckily the machine I bought is mostly done. I want to add limit switches. Can someone tell me how to wire the switch to this board (trying to post pic also). It is a PM25 originally done by Procutcnc. I am the second owner, Procutcnc will not respond to me, the previous owner warned me that their customer support was ZERO. Hoping someone can give me a quick answer as to where the two switch wires should be plugged in to the board. The board has 4 spots for each axis (+24v, in-, in+, 24vgnd).