Hello Guest it is December 13, 2019, 09:57:03 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - paul

Pages: 1
1
G-Code, CAD, and CAM discussions / RE G31 PROBE COMMAND
« on: June 29, 2006, 07:59:21 PM »
Hi please can anyone help with G31, when reading Mach 3 user's guide it states that you must use " at least 1 axis word " ( page 10-20 ) & " after successful probing parameters 2000 to 2005 will record trip point " page 10-21.

say try this line   code " G31 X50 Y50 "   no movement  I assumed it would move towards X50 Y50 stop when probe trips, is this possible as i need to probe at angle

                       code " G31 X50 " ok

         Many Thanks Paul Strotten

2
General Mach Discussion / VB Script re G68 to edge find
« on: May 13, 2006, 06:06:57 AM »
Hi please can anyone help. this is what i need to do, Use VB script attached to a button,
  probe touch on 2 places on one edge of work piece,
  use G68 to rotate program,
  set X axis to zero,
  also is G68 limited to only 1 decimal place.

             Many thanks Paul
                         From the uk

Pages: 1