Hello Guest it is October 14, 2019, 10:02:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Scalo1

Pages: 1
1
General Mach Discussion / Mach3 running on 64bit windows 10
« on: April 09, 2019, 01:38:38 PM »
Hi all, I am fairly new with this Mach 3 software so I would really appreciate any assistance at all.
So I have just installed the Mach3 software on my x64 windows 10 OS laptop. Every time I try to run one of the sample G-code programmes, only a few lines of the code are executed then the system stops. Not sure why it does this. I have tried also the reinstallation at no avail.

Any one who might shed some light Please!!!!

Pages: 1