Hello Guest it is August 01, 2021, 11:12:50 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - inkwizitiv

Pages: 1
1
General Mach Discussion / Strange Z zero problem
« on: April 09, 2019, 12:31:01 PM »
Can someone please help? When I start a job I zero the tool on the top but when I run it sometimes the Z axis starts + a few millimetres missing the job but when I stop and rewind start again its ok, its as if its reading the Gcode wrong?

Pages: 1