Hello Guest it is November 27, 2022, 07:07:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - weirdbeard

Pages: 1
1
General Mach Discussion / Mach3 Goto Zero issue
« on: April 08, 2019, 05:10:53 AM »
Hello all,
I have a new OMNI 1325 that randomly seems to jam or get stuck on "goto Zero" moves or at the start of running a job in MACH3
I can manually jog the CNC at full speed without issues and when the job is running there are no issues.
If I move the CNC and hit Goto zero maybe 1 in 10 times in will jam as in the video that can be seen here -  https://youtu.be/LUjYjvEOt-M
Most of the time when i do this a thud or clunk can be heard but the move manages to finish as one would expect
Occasionally it will work without any thud,clunk or jam.
Im totally stumped, reducing the movement speed of the Z axis is not the issue as I can manually jog at full speed without issue
I do not understand how the goto zero command in mach 3 is being treated different to just normal Jogging operations and if this is a mach3 setup issue or an issue with the CNC controller
any expert advice would be greatly appreciated as so far OMNI support have been unable to provide any meaningful assistance
Thanks

Pages: 1