Topics

1

General Mach Discussion / How to configure two motors in one axis?

« on: September 17, 2007, 05:16:48 PM »

Hi everyone, I haven’t found anything in the forum about to configure Mach3 to run two step motors in one axis clockwise and counterclockwise ¿Could anybody tell me how to do it?.

      Thanks    Jovimon

2

General Mach Discussion / phase drive control

« on: August 31, 2007, 10:41:52 PM »

Hi everyone, ¿what are the advantages and disadvantages of the phase drive control? ¿Why Mach3 doesn’t include this type of motor control?

          Jovimon

3

General Mach Discussion / Simple drive controller circuit

« on: August 30, 2007, 12:02:38 PM »

Hi, everyone. Does anybody know where to get a simple motor drive controller circuit, that works with Mach3 that I can build, to run a little 3 axis router through a PC, 4 step motors, 1.1 amp., 4.1 volts., microstep ?

        Thanks   Jovimon

4

General Mach Discussion / MDI does not respond

« on: August 14, 2007, 12:22:15 PM »

 Hi to every one: I’m new with mach3 and I’m following step by step the manual, when writing the G-code and press enter, I don’t get any response (I have tried several times with different codes). Does anybody could tell me what could be happening?

           Regards

5

Spanish / El MDI no responde

« on: August 13, 2007, 06:50:18 PM »

Saludo a todos: Estoy siguiendo el manual de Mach3 (al pie de la letra). ¿Podría alguno de ustedes decirme ¿por que cuando escribo algun codigo G no sucede nada?. ¿Que botones deberían estar activados para que ello suceda?.

                    Gracias