1
HiCON Motion Controller / issue after Mach4 4.2.0.5036 upgrade...
« on: March 26, 2023, 12:16:55 PM »
I have the 7766 using Clearpath servos on a G0704. Updated the Mach4 and now when I attempt
to use the MPG (from Vital Systems), the movement is very choppy ending in a following error... all 3 axis, but under MDI it's smooth. I adjusted the accel/decel and the RAS antijerk... moves smooth under MDI, not MPG.
So, I went back to the previous version of Mach and all the MPG issues went away...
On a side note, with the newest one, I could get the HLFB to work and e-stop the system if a servo alarmed out, same lua code will not run with the older version... I will not run it until the alarms work.
What's up with the newest version of Mach4?
Thanks,
Mark
to use the MPG (from Vital Systems), the movement is very choppy ending in a following error... all 3 axis, but under MDI it's smooth. I adjusted the accel/decel and the RAS antijerk... moves smooth under MDI, not MPG.
So, I went back to the previous version of Mach and all the MPG issues went away...
On a side note, with the newest one, I could get the HLFB to work and e-stop the system if a servo alarmed out, same lua code will not run with the older version... I will not run it until the alarms work.
What's up with the newest version of Mach4?
Thanks,
Mark