1
Mach4 General Discussion / Switching license from Mach4 to Mach3
« on: July 14, 2020, 11:12:27 PM »
Can anyone tell me if it is possible to switch a Mach4 licence to Mach3? I have had endless hassles trying to get my controller (horrible CSMIO/P-M with no support from the manufacturers) working properly with Mach4. I did have it all running OK until I upgraded the firmware on the controller - now I cant get the touch sensor to work (although it is wired correctly & led comes on when touched) - and I can no longer control my spindle speed from the GUI.
At this point I am just so frustrated I want to go back to Mach3 & may go back to the cheap Chinese controller I had previously ...
At this point I am just so frustrated I want to go back to Mach3 & may go back to the cheap Chinese controller I had previously ...