1
General Mach Discussion / mach3 problem steppers wont move
« on: March 07, 2019, 03:24:10 PM »
I have a problem with a machine purchased from eBay
The machine has a built-in driver such as in the picture (jp-3163).
I have a connection with the LPT port because after pressing the emergency button I see the message estop.
The problem is that immediately after turning on mach3, stepper motors stop having a holding moment.
After rebooting before turning on mach3, everything returns to normal.
Have you ever had a similar problem?
The machine has a built-in driver such as in the picture (jp-3163).
I have a connection with the LPT port because after pressing the emergency button I see the message estop.
The problem is that immediately after turning on mach3, stepper motors stop having a holding moment.
After rebooting before turning on mach3, everything returns to normal.
Have you ever had a similar problem?