Hello Guest it is October 18, 2019, 12:33:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Route66Retro

Pages: 1
HiCON Motion Controller / Hicon board wiring to fire plasma torch
« on: September 05, 2019, 12:37:23 PM »
Hi, I'm building a plasma table. I'm using Mach4 with the Hicon Integra 7766 board. I have the stepper motors all working properly but I cant find any documentation on wiring the plasma torch. Any help is greatly appreciated!

Pages: 1