Guest
Show Posts
1
Mach4 General Discussion / hybrid servo motor, Pockeys57cnc and mach4
« on: February 15, 2019, 06:10:15 AM »
Hi,
I feel really silly now, the new post button finally appeared after I asked this question in a poll base
I started up my pokeys57cnc board last night, completely novice to cnc and was wondering if someone could please assist in how I can get my hybrid servo motor working to test it. I do not understand the manual as the mapping of pins and so forth. Been looking for videos and can't seem to find any on how to go about mapping your motors enable to do jogging with them. Please be kind enough to assist.
thanks
Jonathan
I feel really silly now, the new post button finally appeared after I asked this question in a poll base
I started up my pokeys57cnc board last night, completely novice to cnc and was wondering if someone could please assist in how I can get my hybrid servo motor working to test it. I do not understand the manual as the mapping of pins and so forth. Been looking for videos and can't seem to find any on how to go about mapping your motors enable to do jogging with them. Please be kind enough to assist.
thanks
Jonathan