Hello Guest it is March 28, 2024, 05:24:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tctswfl

Pages: 1
1
General Mach Discussion / mach3 and Bridgeport Boss5
« on: February 14, 2019, 10:51:38 AM »
I have a old CNC Bridgeport Boss 5 with a cnc conversion kit using the original motors running on Mach3. The machine runs great and very tight. The issue I am having is with x and y axis in straight lines it runs smooth but if I make a circle pocket or bore a hole the machine seems to vibrate a lot and leaves a chatter marks not smooth almost as if the motors are not tuned correctly but not sure. I am cutting cast aluminum and part is very secure so it is not a fixture issue. The machine vibrates while cutting air when doing a circle cu

Pages: 1