Topics

1

General Mach Discussion / C:\Mach3\lasterr.text was not found

« on: July 31, 2022, 10:25:57 AM »

I sometimes get the following error window when I start Mach3 "C:\Mach3\lasterr.text  was not found" I use an ethernet  connection  and windows 10. When I have this error I can load a Gcode program and run it but the movement will be  very shocky with big steps  and high sudden start and stop acceleration. Not usefull.  When I restart the complete  PC and CNC machine the error message  dissapears (sometimes a few start ups are needed) and everything works fine. Anybody knows what this is?

2

Mach3 and G-Rex / shape doesnt come out exactly as designed

« on: June 25, 2019, 06:46:27 AM »

the router accuracy  looks like this (see picture). I dont have used cutter compensation.  I use a 0.6mm router bit. As far as I know just follow the line (very basic).It turns out dramtically bad.

3

Mach3 under Vista / Mach3 Ethernet IP setting

« on: February 04, 2019, 05:32:10 AM »

I try to make a connection Mach3 to CNC routrer via Ethernet (gives status: Find No XHC Nc Ether). I use a ethernet motion controller card with IP address  192 168 1 180. I have to set that IP adress in Mach 3. This should go with the menu "plugIn Control" accourding to the manual. Unfortunatly this menu only gives "Video Window"and no possibility to set IP address. Does anybody know what I do wrong ?