Hello Guest it is March 28, 2024, 05:22:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jeff1973

Pages: 1
1
Mach4 General Discussion / SRO disable
« on: February 16, 2019, 05:58:33 AM »
Hi All,

I Need an M function to disable the SRO especially when taping ,Is this possible with mach4

2
Mach4 General Discussion / Gear box high and low gear
« on: February 06, 2019, 01:17:42 PM »
My mill is almost ready the only major thing left is the spindle abart from small safety nitty gritty that I have to implement but when I finish the spindle I can start generating chips
So I searched alot on the forum try to find something similar but I had no luck
The machine has a hydraulic gear change so I have 2 digital inputs and 2 digital outputs so I do not know from where to start from it also have a VFD so I would like to for example from 0 to 200 rpm on the low gear and from 200 to 1250 rpm on the high gear since I a very new for mach4  I have no idea how I can make the script for it
Can anyone help

3
Mach4 General Discussion / enable output
« on: February 02, 2019, 05:35:50 AM »
Hi All ,

I am pretty new for mach4 but I started playing a bit with it i notice that the enable outputs to come all on at the same time mach3 use to be with some delay between enable1 enabe2 and so on
is it possible to have some delay between enable 0 enable 1 enable 3 like 1sec intervals 

Pages: 1