Topics

1

General Mach Discussion / How to set the actual working table

« on: January 03, 2019, 08:03:29 PM »

Hi everyone happy new year to all, im a beginner with mach 3 and probably on a a router machine 3 axis, i wanted to let the machine know the actual workable table size and where should the machine start to do its job, coz everytime i load a gcode (i make it from the aspire) when i transfer it to mach3 the drawing is too far from the spindle, when i try manually check if i will not exceed the table by jogging it, the axis reach the end of the machine still not reaching the drawing or sometimes obly the half of the drawing...

ps sorry if my terminology might be different coz im noob...

Thank you and hope you guys can help me solve this problem...

God bless.

2

Building or Buying a Wood routing table.. Beginnners guide.. / Setting the Working Table

« on: January 03, 2019, 07:57:44 PM »

Hi everyone happy new year to all, im a beginner with mach 3 and probably on a a router machine 3 axis, i wanted to let the machine know the actual workable table size and where should the machine start to do its job, coz everytime i load a gcode (i make it from the aspire) when i transfer it to mach3 the drawing is too far from the spindle, when i try manually check if i will not exceed the table by jogging it, the axis reach the end of the machine still not reaching the drawing or sometimes obly the half of the drawing...

ps sorry if my terminology might be different coz im noob...

Thank you and hope you guys can help me solve this problem...

God bless.