Hello Guest it is March 28, 2024, 09:02:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - JM2018

Pages: 1
1
General Mach Discussion / New to site - Mach3 homing support needed
« on: January 06, 2019, 09:10:06 AM »
Apologies if this is posted in the wrong area but I’m new to the site and have not managed to find a solution to my homing issue.
Running Mach3/Parallel Port/WinXP
When selecting [Home Ref All] the Z axis travels toward home, hits the home switch and continues to run until the switch is released, once released the DRO will zero and then the Y axis starts until the (Y axis) home switch is activated however the display will not zero until after the home switch is released then the same happens with the X axis.
Have isolated the machine from my break out board and connected 3 micro switches to simulate home switch activation.
As before when selecting Home Ref All each axis runs in their respective direction, actuating the home switch and will only zero the display when the switch is released (not when the switch is initially actuated) at which time the next axis in sequence repeats the same problem
Any help would be appreciated.
Many thanks,

JM2018

Pages: 1