Topics

1

General Mach Discussion / Best computer to run Mach

« on: April 05, 2006, 12:00:53 AM »

Hi all,

I am about to get Mach 3 (or 4?) running on my new engraver (see other post on Hermes Vanguard).

What is the best computer carateristics to run Mach 3/4?

Thanks,

Pierre

2

General Mach Discussion / Hermes Vanguard 6000 engraver

« on: April 01, 2006, 01:03:57 PM »

Hi all!

I am new here although I have been looking into Mach software for years.

I just obtained a used Vanguard 6000 engraver. However, I do not have the computer and software that goes with it. I believe that if I knew the pinout of the DB25 located at the back of the engraver, it could be interfaced directly to a computer using Mach 3/4 software.

In addition, it could be converted to 3D.

Anybody have an idea?

Thanks, and kudos to Art!

Pierre