Hello Guest it is March 28, 2024, 09:54:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cpu224

Pages: 1
1
Mach4 Plugins / Mach4 UB1 UC300ETH
« on: January 22, 2020, 04:54:02 PM »
Hi there
I have Mach4 and a UB1 board with UC300ETH.
I had previously operated with UCCNC and ran very well, including XHC Hb04.
Now with mach 4 I can't get the HB04 to work and Mach4 always forgets the settings for inputs and outputs. After each switch off I have to re-enter the values.
Can someone tell me why.

Best wishes
Torsten

2
Mach4 Toolbox / Mach 4
« on: December 31, 2018, 11:34:48 AM »
Make 4 kotz
I'm pretty annoyed right now. That was an expensive experience.
From Mach3 to Mach4 200 € plus new hardware IP-M on new IP-M276€  because the old hardware does not support Mach4. And it is worse than under Mach3. Then you read in the forum, you must also use the latest Versin so Build 4006 installed. And what's even worse, now all axes are simultaneously referencing, no matter what you set. Whether 1 or 2 or 3 or 4 or 0.
Such a crap, that was an expensive experience. Microsoft could not have done that better either.
I'm a little bit nervous.

Translation by google

Best ragards
Torsten

3
Mach4 General Discussion / Mach 4
« on: December 23, 2018, 07:13:31 AM »
Hello
I have just installed Mach 4 with the IP-M controller.
And now I have 2 questions
1. I have installed a potentiometer for the feed, when I turn it also changes the feed rate on the screen but not the jog, you can change that.
2. I can not find any settings for OEM switches eg. Start-Stop break.

greeting
Torsten

Pages: 1