Topics

1

Mach4 General Discussion / Y axis not repeating

« on: December 29, 2018, 10:21:31 PM »

Guys I just finished my build with a 48x48 router using a ess smoothstepper gecko 540 warp9 running mach4 and when cutting a rectangle my Y axis (bridged/slave) doesn't repeat and leaves about .06 between .125" depth cuts cutting a rectangle that is 5x9. I cant imagine that backlash is causing this. when I step back and forth with a indicator using .01 steps it repeats. I'm at a total loss. if anyone can shed some light on this I would be greatfull

2

Mach4 General Discussion / Mach 4 xml for gecko g540

« on: December 21, 2018, 12:17:53 AM »

Hi guys if anyone has this worked out please share.  I'm stuck.