1
Mach4 General Discussion / Spindle at Speed
« on: January 12, 2019, 08:41:23 PM »
I was hoping someone could shed some light on the "Spindle at Speed" Input.
As per the Manual-The time to accerate the spindle in the slected range. If the “Spindle At Speed” signal is enabled the Accel Time is not need and should be set to zero. Any value in the Accel Time field will be done after the Spindle At Speed signal has been toggled.
I have a good signal, Just doesn't seem to make any difference.
Also have good Index pulse with good RPM and can't get Accel Time to work either.
Any feed back would be appreciated, Thanks for your time.
As per the Manual-The time to accerate the spindle in the slected range. If the “Spindle At Speed” signal is enabled the Accel Time is not need and should be set to zero. Any value in the Accel Time field will be done after the Spindle At Speed signal has been toggled.
I have a good signal, Just doesn't seem to make any difference.
Also have good Index pulse with good RPM and can't get Accel Time to work either.
Any feed back would be appreciated, Thanks for your time.