1
General Mach Discussion / Mach3 plasma + THC 150 issue
« on: December 19, 2018, 06:49:18 AM »
Hi,
I have my DIY plasma with Mach3, Proma 150, floating head and Powermax45.
THC is connected to the raw voltage because I had problem when it was connected to divider (head is constantly go up and down).
Floating head, pierce high and cutting high works OK.
I have some problems.
1. After few seconds (not always) I get very short impulses from THC in down/up direction and then Z DRO change for example to +19mm but torch high is OK.
I have my DIY plasma with Mach3, Proma 150, floating head and Powermax45.
THC is connected to the raw voltage because I had problem when it was connected to divider (head is constantly go up and down).
Floating head, pierce high and cutting high works OK.
I have some problems.
1. After few seconds (not always) I get very short impulses from THC in down/up direction and then Z DRO change for example to +19mm but torch high is OK.