Guest
Show Posts
1
Mach3 under Vista / Mach3 and TB6600 under Win7 cant run motors
« on: December 17, 2018, 08:27:11 PM »
Hi all!
I've started assembling DIY Cnc mill, and I'm stuck with making my stepper motors to run. I'm using mach3 interface board, TB6600 4A drivers, mach 3 software on windows 7 x86.
Board and drivers are wired like this
https://ibb.co/Lv1QQzd
step and direction pins are set as 2,3;4,5;6,7; e-stop is set active low on pin 15 (if matters).
For power supply I'm trying to use 12v from PC power supply.
In device manager I have some Mach3 pulseing engine driver with question mark, but I'm unable to find the right driver to install.
First time I connected mach3 board I heard relay clicked and 2 leds were lighted. and now only lights one, and other lights only when I disconnect LPT cable.
I have tryed with other PCI card and changing address, and I'm getting green led on driver when pressing arrows, but motor just don't want to move.
Is there any idea for helping me?
Thanks.
I've started assembling DIY Cnc mill, and I'm stuck with making my stepper motors to run. I'm using mach3 interface board, TB6600 4A drivers, mach 3 software on windows 7 x86.
Board and drivers are wired like this
https://ibb.co/Lv1QQzd
step and direction pins are set as 2,3;4,5;6,7; e-stop is set active low on pin 15 (if matters).
For power supply I'm trying to use 12v from PC power supply.
In device manager I have some Mach3 pulseing engine driver with question mark, but I'm unable to find the right driver to install.
First time I connected mach3 board I heard relay clicked and 2 leds were lighted. and now only lights one, and other lights only when I disconnect LPT cable.
I have tryed with other PCI card and changing address, and I'm getting green led on driver when pressing arrows, but motor just don't want to move.
Is there any idea for helping me?
Thanks.