Topics

1

Mach4 General Discussion / Z probing direction reversed

« on: December 19, 2018, 02:36:52 PM »

This has probably been answered some in a previous post however the search function is not working. So, what happens is that when I go to do a Z probe, it goes up instead of down. jogging, G0, G1 all work correctly in the Z direction. However, executing a probe in the Z axis either from the probe module or the MDI using a G31.1 results in the Z axis going up! Does anyone have any idea what could be causing this?

2

Mach4 General Discussion / jogging increments.

« on: December 15, 2018, 05:13:52 PM »

I have my machine newly configured in metric. Status codes at bottom say that G21 is enabled. However, when I jog 0.1000 both machine and DRO move 2.54mm, 0.1". Could anybody tell me how to change the units on the jog screen as they appear to be outputting in imperial although metric is set in the configuration?