Hello Guest it is November 27, 2022, 07:37:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jrga01

Pages: 1
1
General Mach Discussion / Help please! Work is way outside of table.
« on: December 14, 2018, 05:51:27 PM »
Hey guys new here. Just messing around with the software and come across a weird problem. Using a mill. When i Load Gcode from mastercam into mach 3, it shows the toolpath correctly, but its in the very far bottom left of the display screen and zeroing the offsets does not work.
I first ref all home on the machine, then move the work to the tool press the zero buttons and then regen toolpath... toolpath is still way off to the bottom left on the display screen, displaying outside of my defined table dimensions...
I've been at the problem now for a few days and I'm totally stumped!

help!

Pages: 1