Hello Guest it is December 04, 2021, 09:33:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Sirsparksalot

Pages: 1
1
General Mach Discussion / To smoothstepper or not?
« on: December 07, 2018, 02:07:56 PM »
For any of you that have made the transition to using a smoothstepper in place of the typical dB 25 cable , how much of a difference ,if any, has it made to the performance of your setup? I was having signal loss issues and the mfg the has recommended going with a smoothstepper to help and says the machine will run better and faster  with that addition. Now for most of what I do my machine is plants fast enough but if I can do some jobs quicker that would be a plus . I’d like to hear from someone who has made the switch personally

2
General Mach Discussion / random Z plunge issue
« on: December 03, 2018, 12:21:43 PM »
ok long story short I've been using mach 3 since July on a new cnc router without issue until a few weeks ago when it has started randomly plunging the Z axis through work piece into the table breaking bits and trashing the sheet . i have ran it for months 8-10 hrs a day without issue till just recently, running the same exact programs from before the issue started. i havent changed a single setting other than the rapid speeds between cuts . also if it makes a difference i am doing all my designing and g-code generation with V-carve9.0
 any help would be greatly appreciated ......this is costing me a fortune in bits and wood!

Pages: 1