1
General Mach Discussion / Permanent "Home Switch Triggered" Error
« on: April 02, 2019, 07:50:53 PM »
Hi,
CNC is China Zone CNC 6040 connected by USB to laptop running Windows 7 SP1.
Starting Mach3 shows Status: Device Error Triggered; selecting Reset changes the status to HomeSwitch Triggered. At no stage did the 6040 trigger any limit switch.
I have reinstalled Mach3 but the problems remain.
Any assistance would be greatly appreciated.
CNC is China Zone CNC 6040 connected by USB to laptop running Windows 7 SP1.
Starting Mach3 shows Status: Device Error Triggered; selecting Reset changes the status to HomeSwitch Triggered. At no stage did the 6040 trigger any limit switch.
I have reinstalled Mach3 but the problems remain.
Any assistance would be greatly appreciated.