1
General Mach Discussion / JogOn - Question/Problem - Macros
« on: December 01, 2018, 11:33:04 AM »
I was hoping to add a custom switch that would stop a JogOn() within a give M code. I have made the macro as per the documentation but have found that JogOn(2,0), does not move the machine in the Z axis in the positive direction when place inside a M call.
Am I going about this in the right way?
Do I need to something extra to allow this function?
Thank you
Am I going about this in the right way?
Do I need to something extra to allow this function?
Thank you