1
General Mach Discussion / G31 won't follow feed rate
« on: November 27, 2018, 05:23:32 AM »
I've been trying to figure this out for about a week with no leads.
When I first start mach3 the probe z tool feeds nice and slow. After I run a program the probe z function feeds at full rapid. Once this happens ref all home also feeds at full rapid.
I've tried changing the feed rate in the macro and it has no effect.
When I first start mach3 the probe z tool feeds nice and slow. After I run a program the probe z function feeds at full rapid. Once this happens ref all home also feeds at full rapid.
I've tried changing the feed rate in the macro and it has no effect.