1
General Mach Discussion / No Motor movements
« on: December 04, 2018, 05:05:27 PM »
Hi People. Just built a homebrew CNC machine with plans from Hobby CNC.
Installed Mach 3, The program seems to like my computer ran the Driver test program, setup all the correct parameters I think according to the website for their controller, all the wiring checks out.
Problem I have is the X axis motor only turns one way, it sounds good, Y & Z axis do not move at all, though Z axis motor make a noise but does not turn.
Any help appreciated Thanks David.
Installed Mach 3, The program seems to like my computer ran the Driver test program, setup all the correct parameters I think according to the website for their controller, all the wiring checks out.
Problem I have is the X axis motor only turns one way, it sounds good, Y & Z axis do not move at all, though Z axis motor make a noise but does not turn.
Any help appreciated Thanks David.