Hello Guest it is July 03, 2022, 06:57:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Stvktchn

Pages: 1
1
Hello so I have not really had much luck getting my machine set up properly. I try running the skull and crossbones it runs through the code but it never touches the work piece. So I try some Gcode that I created which is just a circle .25 deep and it just plunges into work piece and bottoms out.  Any help would be great

Pages: 1