Hello Guest it is October 07, 2022, 06:40:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - idcreate

Pages: 1
General Mach Discussion / Control VFD/Spindle via Breakout board and mach3.
« on: November 23, 2018, 05:54:27 AM »

I can't get the forum search to work.. something about spell check.

Is there anyone who can point me in the direction of topics regarding spindle wiring and setup so that it can be controlled through mach3? I'm sure it's been covered here numerous times.

VFD: Huanyang HY02D223B, 2.2kw Chinese

Breakout Board: HY-jk02-M, with relay and analog 0-10v for speed control.

Many hours of searching, fiddling and head scratching have led me here.  ???
I can get the relay to fire, which leads me to believe that the software is talking to the breakout board, but that's as far as i can get.

Thanks in advance.

Pages: 1