1
Mach3 under Vista / Changing stepper motors with more amp draw
« on: December 10, 2018, 01:58:06 PM »
Hi all,
Very green to all of this, so bear with me...
We replaced our green 3 amp stepper motors on the X axis with 5 amp stepper motors. Once running the machine started tapering X axis cuts. We are going to change all 4 motors on the table to the black 5 amp motors. Is there anything we need to change in Mach 3 to make for a smooth transition? Both motors have 200 steps per rev. Running Windows 7 Ultimate.
Any help on this would be appreciated.
thanks in advance.
_
Very green to all of this, so bear with me...
We replaced our green 3 amp stepper motors on the X axis with 5 amp stepper motors. Once running the machine started tapering X axis cuts. We are going to change all 4 motors on the table to the black 5 amp motors. Is there anything we need to change in Mach 3 to make for a smooth transition? Both motors have 200 steps per rev. Running Windows 7 Ultimate.
Any help on this would be appreciated.
thanks in advance.
_