1
General Mach Discussion / HELP!! MACH3
« on: November 19, 2018, 02:08:19 AM »
Hi,
Im new here and im not sure if I am posting this question in the right forum page. With regards to my problem, I don't know what happened but whenever I open a file that I would be engraving, the image would be away from the limit of the table of our machine. I am using a Precix 9000 router with mach 3 software. im attaching some pictures of the problem that I am encountering. I do hope someone can help me
Im new here and im not sure if I am posting this question in the right forum page. With regards to my problem, I don't know what happened but whenever I open a file that I would be engraving, the image would be away from the limit of the table of our machine. I am using a Precix 9000 router with mach 3 software. im attaching some pictures of the problem that I am encountering. I do hope someone can help me