Guest
Show Posts
1
General Mach Discussion / Problem while setting Homing Offset in Mach3
« on: November 25, 2018, 09:33:16 AM »
Hi everybody,
I set up my CNC machine with Mach3 and almost everything works just fine, but I can't figure out how to offset the homing endstop zero.
Right now the homing system works fine except for the fact that I would like to have the Y machine coord set to 600 when endstop is reached, during axis referencing, instead of 0.
I already tried to set the "Home Off." to 600 (in Config -> Homing/Limits), but this doesen't seem to have an effect at all.
I don't know if I'm doing something wrong or if it's kind of a bug in Mach3.
Thanks in advance
I set up my CNC machine with Mach3 and almost everything works just fine, but I can't figure out how to offset the homing endstop zero.
Right now the homing system works fine except for the fact that I would like to have the Y machine coord set to 600 when endstop is reached, during axis referencing, instead of 0.
I already tried to set the "Home Off." to 600 (in Config -> Homing/Limits), but this doesen't seem to have an effect at all.
I don't know if I'm doing something wrong or if it's kind of a bug in Mach3.
Thanks in advance