1
VB and the development of wizards / Internal taper wizard
« on: November 09, 2006, 06:43:48 PM »
In a world where all of us have zero backlash machines this wizard would be fine, but a few of us do not.
The cuts should be made from the inside out, so that the x feed is feeding into the metal, at least that should be the case with shallow number angles. The pressures on the Z axis are minimal.
What think Brian?
Jerry
The cuts should be made from the inside out, so that the x feed is feeding into the metal, at least that should be the case with shallow number angles. The pressures on the Z axis are minimal.
What think Brian?
Jerry