1
General Mach Discussion / Zero plate problem
« on: June 29, 2008, 06:59:29 PM »
I am trying to add a touch plate using the XYZ probe modification from the CNC Zone forum.
The problem I am having is Mach always sees the digitize input as always active (status light on) even if I unplug the parallel cable.
I do have the probe input pin set to active low.
I have Mach on a computer in my office and with the same settings the digitize input is not active (status light off).
Have the same version on both computers and have also tried different versions and reinstalling.
If I change the input to active high the light just stays out and the touch plate still does not work.
Any ideas?
Thanks
George
The problem I am having is Mach always sees the digitize input as always active (status light on) even if I unplug the parallel cable.
I do have the probe input pin set to active low.
I have Mach on a computer in my office and with the same settings the digitize input is not active (status light off).
Have the same version on both computers and have also tried different versions and reinstalling.
If I change the input to active high the light just stays out and the touch plate still does not work.
Any ideas?
Thanks
George