Hello Guest it is March 28, 2024, 04:30:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jpmartr

Pages: 1
1
Mach3 and G-Rex / Home limite mach3 et G100
« on: February 04, 2008, 10:59:12 AM »
Hello!
Please find my problem
I use Mach3 and G100 the Mach3 input are configured like that:
XHOME port 1 pin 17
YHOME port 1 pin 18
ZHOME port 1 pin 19

In this case the origins machine works very well, if I add
X+ + port 1 pin 17
Y+ + port 1 pin 18
Z+ + port 1 pin 19

When the machine made the Z-axis origins, the machine going on ZHOME then emerges ZHOME ( so OK), then the Y axis go on YHOME and a this moment nothing happening mach3 seems block but does not errors I must to do a RESET and then mach3 indicates the error limit switch triggered and what’s normal.

I have try many time but no result, Thanks a lot

Ps: the emulated hotkey is not active

Jean Pierre

Pages: 1