Hello Guest it is March 28, 2024, 09:36:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tiggger ZA

Pages: 1
1
Mach4 General Discussion / Mach4 probe macro
« on: September 02, 2020, 07:31:46 AM »
Good day

I am hoping you can assist me....

I have a probe macro that is doing the following:

Probe for any tool and it writes the distance moved from G54 Z0 to probe initiation into the ToolTable

Probe the same tool again and it measures the movement against the ToolTable offset, resulting in a 0

Probe 3rd time and the ToolTable again measures from G54 Z0

I am using a G31 command in the macro

Do you know of any way to make sure the measurement is always from the Z0?

 I am attaching the macro, if that helps?

I did get the macro off of the forum a while ago, I think it was Chaoticone?


2
Screen designer tips and tutorials / newbie help with button
« on: October 29, 2018, 10:28:21 AM »
Hi guys
completely new to messing with the button functions etc
Friend of mine is looking to have a button added to the axis DRO that will half the readout
ie if the X axis reads 200mm he wants the button to halve it and rewrite the DRO as 100mm...
is this possible?

and if so , how the heck do I do it?

thankooo
Glen

Pages: 1