Hello Guest it is April 26, 2019, 12:35:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Olena

Pages: 1
1
General Mach Discussion / Problems with the A-Axi
« on: October 18, 2018, 06:57:45 PM »
Hi, I'm here because I can not move the A-Axi in Mach3. The Axi is enable but the DRO doesn't move even with commands in MDI. The card that I'm using to controller the Axis is e-cut. The motor work well is for that that I think the problem is the software Mach3 or the controller card.

Pages: 1