Hello Guest it is March 28, 2024, 07:37:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tonys CNC

Pages: 1
1
General Mach Discussion / Problems with Mach 3 , new user.
« on: October 17, 2018, 11:57:25 AM »
Yes, new to Mach 3,  Finished up assembling a CNC Router Parts CNC.  Had a Next Wave CNC before.   
Issues:
With a program from Aspire, The X & Y zero is at the far right end of the table. (Spindle facing me) On the Next Wave machine, it was at the forward left end of the table.   If this is normal, then I must live with that  Is this normal??

When running the G-code in "off Line" mode, the Mach 3 runs the lines of code step by step without missing any steps.  But if I run the G-Code with the spindle running, it misses 100-150 lines of G-code.
That is not normal.

I'm running CNC Router Parts "In." Post Processor. Do not know if that is correct.  Should I run a Mach 3 Post Processor??

Tony K.

Pages: 1