Guest
Show Posts
1
PoKeys / Pokeys, mach4 no go?!
« on: October 10, 2018, 01:25:39 AM »
To make a long story short(er). It started when I wash hooking up the basic things needed to get my oxcnc moving.
Started with this; https://www.youtube.com/watch?v=9u8CvoVQZXc very odd movement, same with pendant or no pendant, it doesnt move cleanly.
Checked other axis, they wont allmost budge, but they are easy to move by hand.
Then I checked further, removed all things keeping a load on the steppers, this is what happens now
https://www.youtube.com/watch?v=Cdbz5dgRhq0 https://www.youtube.com/watch?v=z5oYCf9BRnY
Checked drivers, tried 1/2-1/4 Microstepping.
Thought maybe I did a booboo on the cables, but A+ A- B+ B- seems to connect to where they should
So I checked the motion controller > driver cabling, A Ok there aswell, connected as shown on diagram + alarm,
not sure if wiring this wrong might give me the erors I am having, as a final trial I will be making new basic cables just like this diagram.
Any other final ideas would be awesome
Started with this; https://www.youtube.com/watch?v=9u8CvoVQZXc very odd movement, same with pendant or no pendant, it doesnt move cleanly.
Checked other axis, they wont allmost budge, but they are easy to move by hand.
Then I checked further, removed all things keeping a load on the steppers, this is what happens now
https://www.youtube.com/watch?v=Cdbz5dgRhq0 https://www.youtube.com/watch?v=z5oYCf9BRnY
Checked drivers, tried 1/2-1/4 Microstepping.
Thought maybe I did a booboo on the cables, but A+ A- B+ B- seems to connect to where they should
So I checked the motion controller > driver cabling, A Ok there aswell, connected as shown on diagram + alarm,
not sure if wiring this wrong might give me the erors I am having, as a final trial I will be making new basic cables just like this diagram.
Any other final ideas would be awesome