1
General Mach Discussion / Macro in G-code pauses execution for 1 sec
« on: September 27, 2018, 02:26:28 AM »
Hello,
I have a problem with executing macros. Everything runs smoothly except when the code needs to run macro, for example M29, which just disables movement on axis A, it pauses just for 1 second and after that it continues normally.
I am using Mach3, Hicon integra board and Leadshine drivers.
I would like it to run without this 1 second pause. Where does the problem lies. What do I need to fix. Thank yiu for your answers.
I have a problem with executing macros. Everything runs smoothly except when the code needs to run macro, for example M29, which just disables movement on axis A, it pauses just for 1 second and after that it continues normally.
I am using Mach3, Hicon integra board and Leadshine drivers.
I would like it to run without this 1 second pause. Where does the problem lies. What do I need to fix. Thank yiu for your answers.