Hello Guest it is March 28, 2024, 04:16:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nemoc

Pages: 1
1
General Mach Discussion / Art Code:8877
« on: April 25, 2012, 05:55:43 PM »
Hello people, can someone help me with this message?
 "Art Code: 8877."
 What does it mean?
 Where can I get an error table?

Thanks

NEMO

2
General Mach Discussion / Pullback DRO
« on: January 16, 2011, 01:53:40 PM »
Could someone tell me what are the OEM 91 and 93 DRO?
 How do they work?
 OEM 91 is the pullback DRO?

thanks

Nemo

3
Screen designer tips and tutorials / Adding screen
« on: October 16, 2009, 02:28:12 PM »
To facilitate my work,I added two new screens to my own Mach3 screenset.
The first screen allows me to even(leveling) a board using the probe. The probe tap  three points previously chosen. The difference of level between the three points is recorded and displayed on the screen allowing repositioning of the board. The first point will be automatically set as zero-tool. The choice of three points can be made by the distance between them or by coordinates previously defined in the drawing. See picture below Nivelar_1 or a video on

http://www.youtube.com/watch?v=utn-yDiI6ms

The second screen allows me to align a side of a board for X or Y. The probe tap two points previously selected in a given axis, records the difference between them and displays the results on the screen, allowing repositioning the part.
The first point to be taped will be automatically registered as zero-tool in that axis.
This procedure when carried out in both axes (X, Y) defines the point (0,0) in a corner, depending on the chosen quadrant.
The points are defined by distance between them, or by coordinates and the choice of the quadrant area of work.
See picture below Alinhar_1 , or a video on

http://www.youtube.com/watch?v=cMwaKtLm3xw
http://www.youtube.com/watch?v=iVxZhxARmtE

Nemo

4
General Mach Discussion / trouble with steps or with stream pulses
« on: August 25, 2007, 03:47:56 PM »
Hello, I’m new to Mach3 and English isn’t my natural language therefore I’m sorry for something unintelligible.
      I think that the subject is trouble with steps or pulses.  ???
Before I post I have read everything that I found here about the subject , and I did most of  things that are indicated but don't fix my problem .
I have a little router (a homebrew CNC) that I build four years ago:
Step motors (130N-cm; 2A), ball screw (0.2in/rev), PowerSuply (38V-330W), stepdrivers optoisolated (L297+L6203), breakout board is buffered.
PC – Asus-AMD-Atlhon 1800+, Ram 256Mb
Recent I bought a Mach3 license and after this I’m running another CNC control.
Now I’m running   Mach3VersionR2.00.053.
This is the problem: When I move any axis (jog/MDI/program) I get a cumulative error, something about 0.001 inches although the DROs show the exact displacement programmed. This occurs in one direction but not in the other for the same axis.  The error is consistent and is the same for all axes (x, y, and z). Can someone Help me ?

NEMO

Pages: 1