Hello Guest it is March 28, 2024, 03:11:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - vidio1

Pages: 1
1
General Mach Discussion / Denford Lathe
« on: September 27, 2018, 09:34:58 AM »
 I just purchased a Denford Mirac from a tech. school auction. It's complete with the control box, IE power supply, drives, etc. I've been waiting on a reply about Denford's control software for a few days now which leads me to my question. Can I just assign which pins do what and assign high or low using Mach3 to get it to move, or would I need to do a rebuild on break-out boards and start from scratch?

Pages: 1