Hello Guest it is March 31, 2020, 06:14:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kwheat

Pages: 1
1
General Mach Discussion / z axis cutting to deep
« on: August 22, 2018, 02:16:55 PM »
We cut foam 3d figures from sliced models. was cutting fine then started cutting to deep. Have checked home part zeros but no luck.  see pics any ideas? using Aspire. tool path preview looks good.

Pages: 1